Assembling Your S.S. Wheeled Shooting Stool

Get a printer-friendly version of our assembly instructions here. (*.pdf)
You will need Adobe Acrobat Reader to download this file.

Parts List: Three (3) S.S. tubing pieces Two (2) wheels One (1)  axle A small plastic bag containing the following hardware:

HARDWARE LIST:

• Two (2) ¼” X 2 ½” Hex bolts
• Two (2) ¼” X 2 ½” Carriage Bolts
• Six (6) ¼” Flat Washers
• Two (2) ¼” Wing Nuts
• Two (2) ¼” Nylocks
• Four (4) Special Curved Washers
• Two (2) ½” Flat Washers
• Two (2) Spring Clips

The main upright handle is already full assembled.

The fold down table is shipped with a PVC covering to protect the aluminum finish.  You may wish to remove it after assembly of your Shooting Stool, but removal is not necessary.  The PVC covering will continue to provide long term protection for your table. 

First place your bag on the two smaller stool halves. Be sure you have the bag facing in the direction you want before you proceed.

Next install a 2 1/2” bolt in either side of the two halves.  Be sure to install a 1/4” flat washer on the inside, outside, and in between each of the tubing pieces on both sides.  Install a 1/4” Nylock on each bolt. Do not over tighten these bolts as it will make the stool harder to collapse. The  Nylocks will keep the bolts from unscrewing. Tightness is not important.

Next install the aluminum axle through the holes in the end of the stool halves.  Put a 1/2” flat washer on the outside of each tube.  Then install the wheels.  Next place a spring clip on the end of the axle.

Locate the holes provided for mounting the long handle. Place a 2 1/2” carriage bolt, with a special half round washer through the tubing on either side. Next place the long top handle under the tubing sides, allowing the carriage bolts to pass through the holes provided. Put another special half round washer on each bolt, and screw on a wing nut.  Be sure that the square of the carriage bolt fits into the square of the half round washer.  It is designed to keep the carriage bolt from turning when tightening the wing nut.

That’s all there is to it! Now go and enjoy your new S.S. Wheeled Stool.  If there are any questions, or suggestions, please feel free to call, or e-mail anytime.

Thanks for purchasing our product.

Bob Schneller

Click on any photos on this page for an enlarged version.

Back to S.S. Wheeled Shooting Stool Page